Sangean WR-3 Manuál s instrukcemi stáhnout pdf (Strana 10)

Scan tuning via remote control device

Switch on your radio by pressing the power button .

Select the required waveband .

Press and hold down either the tuning up or down button until the freque

ncy in the display

begins to change rapidly . Release the button .

Your radio will scan the selected the waveband , stopping each time it finds a station of

sufficient strength . Adjust the volume control to the required level .

Rotary manual tuning

Pres

s the on/off button to switch on your radio .

Select the required waveband by repeatedly pressing the Band button .

Rotary tuning the Tuning knob will change the frequency in the following increments ,

FM 50 kHz or 100 kHz

MW 9 kHz or 10 kHz

Set the

volume and tone controls to the desired settings .

To switch off your radio , press the On/Off button .

Presetting stations

There are 5 memory presets for each FM and MW wavebands .

Press the On/Off button to turn on the radio .

Tune to the required stat

ion using one of methods previously described .

Press and hold down the required Preset button until the radio beeps ( greater than 2

seconds ) . The preset number will appear in the display and the station will be stored

under the chosen preset button .

epeat this procedure for the remaining presets .

Stations stored in preset memories may be overwritten by following the above procedure .

Recalling a preset station

Press the On/Off button to turn on the radio .

Select the required waveband by repeatedly

pressing the Band button .

Momentarily press the required Preset button , the preset number and station frequency

will appear in the display .

Volume and Tone control

Rotary the volume control knob to set the required volume level , display will show volu

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

Sangean WR-3 Manuál s instrukcemi Strana 10